![]() ![]() This was a request from a friend to create something with a cube and future-looking, without losing any airflow. ![]() HexaCube Neck (Diameter=46mm, Height=140mm): this module looks quite menacing to print without supports for the hexagonal cage, but it is quite easy actually (they are 60 degree overhangs), support from build plate is suggested to print the bottom insides well. Pillars Neck (Diameter=46mm, Height=140mm): this module is relatively easy to print, adds a cool look and slightly cools down the smoke by exposing it to more surfaces, support from build plate is suggested to print the bottom insides well. Svelte Neck (Diameter=46mm, Height=140mm): this module is relatively easy to print, equal in size and function to the Straight Neck (from the Basic Pack), but shaped like a handle with a diameter of 24mm, to have a nice firm grip on your bong. The pieces included and the difficulty of printing are: This pack includes some modules which work with any other part of the 3D printed bong (check it out in my designs!).Īll modules have been designed to work properly and efficiently, but some are harder to print (read below), and most have a overhang toward the top which can be easily accomplished with a good cooling system (it is a 60 degree angle). ![]() This is the 3D Printed Bong Expansion pack! ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |